A newer version of this documentation is available.

View Latest

Install Couchbase Server on SUSE Linux Enterprise Server

      Couchbase Server can be installed on SUSE Linux Enterprise Server for production and development use-cases.

      Use the instructions on this page to install Couchbase Server on SUSE Linux Enterprise using Couchbase-provided RPM packages. The instructions support both Enterprise and Community editions.

      If you’re upgrading an existing installation of Couchbase Server, refer to Upgrading Couchbase Server.

      Before You Install

      Couchbase Server works out-of-the-box with most OS configurations. However, the procedures on this page assume the following:

      For production deployments, make sure to follow the deployment guidelines so that your systems and environment are properly sized and configured before installation.

      Basic Installation

      You must be logged in as root (superuser) or use sudo to run the installation commands.

      Install Using RPM Package

      Install Couchbase Server on SUSE Linux Enterprise using a full RPM package provided by Couchbase.

      1. Download the appropriate package from the Couchbase downloads page.

      2. Install Couchbase Server.

        sudo rpm -i package-name.rpm

        Once installation is complete, Couchbase Server will start automatically (and will continue to start automatically at run levels 2, 3, 4, and 5, and explicitly shut down at run levels 0, 1, and 6). You can use the systemctl command (service on older operating systems) to start and stop the Couchbase Server service, as well as check the current status. Refer to Couchbase Server Startup and Shutdown for more information.

      3. Open a web browser and access the Couchbase Web Console to verify that the installation was successful and the node is available.

      Installing as non-root, non-sudo

      The procedures for non-root installation, upgrade, and uninstallation — which are the same for all supported Linux distributions — are provided at Non-Root Install and Upgrade.

      Starting and Stopping a Non-Root-Installed Couchbase Server

      1. To run the server use

        ./bin/couchbase-server -- -noinput -detached
      2. To stop the server use

        ./bin/couchbase-server -k

      Next Steps

      Following installation and start-up of Couchbase Server, a node must be initialized and provisioned.

      • If it is the first node in a deployment, initialization and provisioning happens all at once when you create a cluster of one.

        Refer to Create a Cluster

      • If you already have an existing cluster, the node is initialized and provisioned when you add it to the cluster.

      • Optionally, initialization can be performed explicitly and independently of provisioning, as a prior process, in order to establish certain configurations, such as custom disk-paths.